PRIME-LINEPrime-Line M 6145 Aluminum Frameless Shower Door Top Bracket Roller Assembly, 3/4 In. Round Plastic Wheel, Fits 3/16 In. Glass (2 Pack)

This is a perfect replacement for the broken door hangars. One note. The plastic inserts are pretty worthless as I could not get the bracket on the glass with the insert in place. There were no inserts on the broken ones I was replacing so I just used some electrical tape and it worked fine.

These did not fit on my shower door at all and even if I left the rubber gasket out, I couldn't get the screws to tighten at all. I ended up just tearing the shower door out and replacing it with a shower curtain.

Shower doors are working well and slide back and forth again.

We used this product on glass doors. We had to open up the bracket to make it fit over the rubber piece. We also had to make additional adjustments by screwing screws tighter to stop it from slipping. It does work however I feel that the manufacturer should also include the silicone as an option instead of just the rubber piece. It’s been a week and it hasn’t slipped and doesn’t look like it’s moved. I gave it four stars just because I would feel more comfortable with the silicone.

Clamp did not work but rollers did. Transfered rollers to old clamps.

Took a while to figure out how to get the clamps installed on the glass door and the instructions are very lacking in any detail or instruction. I could not get the rubber pieces onto my door would the clamp they would not fit, after reading in the details on here I found that I only need the rubber pieces if my door already had them on. Otherwise I should use silicon calking under the clamp. So I used silicon calk, let them sit for 24hrs, and then installed the doors. Had zero problems with them sagging or anything, rollers are great and so much better then my old ones.

I needed to secure and slide acrylic door for our drum booth at church. because is was some kind of plexi you can't just drill it without accidentally putting more pressure than needed and cracking it. so walking through and hardware store, I saw a glass shower door with this guys on. I gave it a shot and voila! since plexi is so much lighter than those glass doors, it works perfect, even without the rubbers that it comes with. great simple product!

Update- with the problems that I mentioned below, and my being unsure of a safe installation after the rubber gaskets broke on installation I got bad news today— the glass door fell out of the newly installed brackets onto my neighbor’s foot, shattering the glass door and requiring 12 stitches in her foot. BEWARE. I purchased a set to help an elderly neighbor reinstall the sliding glass door to her shower. The glass size is 3/16". However, when trying to install the roller assy. onto the glass, the width of the glass plus the rubber gasket was too large to accept them. I had to install the rollers without the gasket and I don't see that as a good fit- metal on glass? No! The assy. needs to be slightly larger to allow the gasket to be placed on the glass and then the assy. tightened to hold the glass up. Very disappointed.